Table of Contents
Advertisement
Operation
IRC-6 Infrared Remote Control
The EZpar T6 USB is compatible with the IRC-6 infrared remote control from Chauvet. To activate IR
mode, follow the instructions below:
1.
Press <MENU> repeatedly until SEt shows on the display.
2.
Press <ENTER> to accept.
3.
Press <UP> or <DOWN> to select on or oFF.
4.
Press <ENTER>.
IRC-6 Operation
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
To adjust the speed of the automatic program:
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
Manual Color Control
To choose a specific color with the IRC-6:
To manually control the RGB percentage:
To turn the SMD strobes on or off:
Miscellaneous Operation
To adjust the total output level:
To adjust the strobe rate of the static color:
To select a fading program:
To black out the lights:
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>.
You may have inadvertently activated Black Out.
EZpar T6 USB User Manual Rev. 2
1.
Press <AUTO> on the IRC-6.
2.
Press <+> or <–> to choose between the different auto programs.
1.
Press <SPEED> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the speed of the program.
1.
Press <SOUND> on the IRC-6.
2.
Press <+> or <–> to select a sound-active program.
1.
Press any number between <0>~<9> to choose your color.
2.
Press <+> or <–> to choose between preset static colors.
1.
Press <MANUAL> on the IRC-6.
2.
Press <R> (red), <G> (green), <B> (blue), or <UV>/<P> (UV) to choose
your color.
3.
Press <+> or <–> to increase or decrease the percentage of each color.
1.
Press <W> on the IRC-6.
1.
Press <%> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the output level.
1.
Press <STROBE> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the strobe rate.
3.
Set to S000 to turn off the strobe.
1.
Press <FADE> on the IRC-6.
1.
Press <BLACK OUT> on the IRC-6.
Page 9 of 15
Advertisement
Table of Contents
