Master/Slave Mode - Chauvet FREEDOM FLEX H4 IP User Manual

Master/Slave Mode

The Master/Slave mode allows a single Freedom Flex H4 IP product (the "master") to control the actions of
one or more Freedom Flex H4 IP products (the "slaves") without the need of a DMX controller or DMX
cables. The master (transmitter) product will be set to operate in either Stand-Alone mode or with the IRC-6,
while the slave (receiver) products will be set to operate in Slave mode. Once set and connected, the slave
products will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select drCH.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select the receiving D-Fi channel, from dr 1–16.
6. Press <ENTER>.
7. Finish setting all the slave products.
Master product:
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select dtCH.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select the transmitting D-Fi channel on which the slave products are
receiving, from dt 1–16.
6. Press <ENTER>.
7. Set the master product to operate in Stand-Alone mode or with the IRC-6.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
Page 13 of 17 Freedom Flex H4 IP X6 User Manual Rev. 2
Operation