Table of Contents
Advertisement
O
PERATION
IRC-6 Infrared Remote Control
The Rotosphere Q3 is compatible with the IRC-6 infrared remote control from Chauvet. To activate IR
mode, follow the instructions below:
1.
Press <MENU> repeatedly until SEt shows on the display.
2.
Press <ENTER> to accept.
3.
Press <UP> or <DOWN> to select on or oFF.
4.
Press <ENTER>.
IRC-6 Operation
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
To adjust the speed of the automatic program:
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
To adjust sound sensitivity in Sound-Active mode:
Manual Color Control
To choose a specific color with the IRC-6:
To manually control the RGB percentage:
Miscellaneous Operation
To adjust the total output level:
To adjust the strobe rate of the program:
To select only fading programs:
To black out the lights:
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>.
You may have inadvertently activated Black Out.
Rotosphere Q3 User Manual Rev. 1
1.
Press <AUTO> on the IRC-6.
2.
Press <+> or <–> to choose between the different auto programs
1.
Press <SPEED> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the speed of the program.
1.
Press <SOUND> on the IRC-6.
2.
Press <+> or <–> to select Snd1 Snd2 or Snd3.
1.
Press <SENSITIVITY> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the sound sensitivity.
1.
Press <MANUAL> on the IRC-6.
2.
Press any number between <0>~<9> to choose your color.
1.
Press <MANUAL> on the IRC-6.
2.
Press <R> (red), <G> (green), <B> (blue), or <W> (white) to choose your
color.
3.
Press <+> or <–> to increase or decrease the percentage of each color.
1.
Press <%> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the output level.
1.
Press <STROBE> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the strobe rate.
3.
Press <STROBE> again to turn off the strobe.
1.
Press <FADE> on the IRC-6.
2.
Press <+> or <–> to select XX or XX.
1.
Press <BLACK OUT> on the IRC-6.
Page 13 of 18
Advertisement
Table of Contents
