Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet FXarray Q5 Fxarray Q

Hide thumbs Also See for FXarray Q5:
Table of Contents

Advertisement

O
PERATION

IRC-6 Infrared Remote Control

The FXarray Q5 is compatible with the IRC-6 infrared remote control from Chauvet. To activate IR mode,
follow the instructions below:
1.
Press <MENU> repeatedly until SEt shows on the display.
2.
Press <ENTER> to accept.
3.
Press <UP> or <DOWN> to select on or oFF.
4.
Press <ENTER>.

IRC-6 Operation

Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
To adjust the speed of the automatic program:
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
Manual Color Control
To choose a specific color with the IRC-6:
To manually control the RGB percentage:
NOTE: Only three colors can be used at once.
To set all LEDs to full intensity:
Miscellaneous Operation
To adjust the output level of the Quad LEDs in an auto program:
To adjust the strobe rate of the static color:
To select a fading program:
To black out the lights:
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>.
You may have inadvertently activated Black Out.
FXarray Q5 User Manual Rev. 1
1.
Press <AUTO> on the IRC-6.
2.
Press <+> or <–> to choose between the different auto programs.
1.
Press <SPEED> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the speed of the program.
1.
Press <SOUND> on the IRC-6.
2.
Press <+> or <–> to select a sound-active program.
1.
Press any number between <0>~<9> to choose your color.
2.
Press <A> to cycle through preset static colors.
1.
Press <R> (red), <G> (green), <B> (blue), or <UV>/<P> (UV) to choose
your color.
2.
Press <+> or <–> to increase or decrease the percentage of each color.
1.
Press <W> on the IRC-6.
1.
Press <%> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the output level.
1.
Press <STROBE> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the strobe rate.
3.
Set to S 0 to turn off the strobe.
1.
Press <FADE> on the IRC-6. Press it repeatedly to cycle through fading
programs.
1.
Press <BLACK OUT> on the IRC-6.
Page 11 of 16

Advertisement

Table of Contents
loading

Table of Contents