Product At A Glance; Safety Notes - Chauvet FREEDOM FLEX H4 IP User Manual

Before You Begin

Product at a Glance

Use on Dimmer
Outdoor Use
Sound-Active
DMX
Master/Slave

Safety Notes

• This product is not intended for permanent installation.
• Always connect the product to a grounded circuit to avoid the risk of electrocution.
• Always turn off the Freedom Flex H4 IP before cleaning.
• Always disconnect the charging case from power before cleaning or replacing the fuse.
• Avoid direct eye exposure to the light source while the product is on.
• Make sure the power cord is not crimped or damaged.
• Never disconnect the product from power by pulling or tugging on the cord.
• If mounting the product overhead, always secure to a fastening device using a safety cable.
• Make sure there are no flammable materials close to the product when operating.
• Do not touch the product's housing when operating because it may be very hot.
• Do not charge the battery of the product in a closed case or container.
• The voltage of the outlet to which you are connecting this product must be within the range
stated on the decal or rear panel of the product.
• This product is for indoor or temporary outdoor use (IP54). Do not expose to harsh or
excessively corrosive environmental conditions (whether indoors or outdoors), including,
but not limited to, extreme temperatures, humidity, atmospheric conditions (including salinity
or pressure), radiation (UV, infrared or nuclear), shock and conditions which exceed the
product's Ingress Protection (IP) rating.
• This product may be exposed to rain and moisture.
• Always install the product in a location with adequate ventilation, at least 20 in (50 cm) from
adjacent surfaces.
• Never connect the product to a dimmer or rheostat.
• Make sure to replace the fuse with another of the same type and rating.
• The maximum ambient temperature is 104 °F (40 °C). Do not operate this product at higher
temperatures.
• In the event of a serious operating problem, stop using the product immediately.
• Do not open this product. It contains no user-serviceable parts.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Keep this User Manual for future use. If the product is sold to someone else, be sure that
they also receive this document.
Freedom Flex H4 IP X6 User Manual Rev. 2

Auto Programs

Auto-ranging Power Supply

Replaceable Fuse

User-Serviceable





Page 2 of 17