Battery Charge Notes; Mounting; Orientation; Rigging - Chauvet FREEDOM FLEX H4 IP User Manual

Table of Contents

Advertisement

Setup

Battery Charge Notes

Avoid depleting the battery below 10%.
For best results, charge the battery in a temperature between 32 °F (0 °C), and 95 °F (35 °C).
When charging the battery, keep the product at least 1 m from any open flame or hot plate.
If the battery is completely discharged, the device cannot be turned on immediately when the
charger is connected. Allow a depleted battery to charge for a few minutes before turning on the
device.
While charging, the device may heat up. This is normal and should not affect the device's lifespan
or performance. If the battery gets hotter than usual, the charger may stop charging.
When charging the battery, keep the charging case's cover open.
Always charge the battery with the product in an upright position.
Do not charge the battery for more than 24 hours.

Mounting

Before mounting the product, read and follow the safety recommendations indicated in the

Orientation

The Freedom Flex H4 IP may be mounted in any position; however, make sure adequate ventilation is
provided around the product.

Rigging

Before deciding on a location, always make sure there is easy access to the product for
maintenance and programming.
Make sure adequate ventilation is provided around the product.
Make sure that the structure or surface onto which you are mounting the product can support the
product's weight. (see the
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
The rubber feet also serve as floor supports and allow for surface mounting. When mounting the
product on the floor, make sure that the product is away from people and vehicles.
Mounting Diagram
Safety Cable
(such as CH-05 from
Chauvet)
Freedom Flex H4 IP X6 User Manual Rev. 2
Technical
Specifications)
Safety
Notes.
Mounting Clamp
(such as CLP-15 or CLP-15N
from Chauvet)
M12 Threaded Mounting Hole
Kensington Security Slot
Page 6 of 17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents