External Sensor Connector - Thermo Scientific NESLAB EX Series Installation, Operation And Maintanance Manual

External Sensor
Connector
Configuration error
Invalid timer setting, see page 25
Offset setting = ---, or not defined, see page 26
Feature not available because communication mode
is enabled
Unit reaction to warning/fault errors depend on how the unit is configured, see
Setup/Tuning Loop on page 21. The unit is shipped configured to continue
running. If any other code appears contact Thermo Fisher customer service.
The unit is equipped with a male 9-pin D-connector located on the rear of the
control box. The connector is used with an optional external sensor.
Pin # Function
1 3-wire RTD connection A
2 No connection
3 No connection
4 3-wire RTD connection A
5 No connection
6 No connection.
7 3-wire RTD connection B
8 No connection
9 No connection
Hardware Internal Connector
AMP Part# 745492-2
- 40 -
Mating Connector
AMP Part# 745491-2