Compliance; Weee/Rohs; Unpacking - Thermo Scientific NESLAB EX Series Installation, Operation And Maintanance Manual

Compliance

Listed to:
UL 61010-1 2nd Edition
CSA C22.2 #61010.1 2nd Edition
Products tested and found to be in compliance with the requirements defined in
the EMC standards defined by 89/336/EEC as well as Low Voltage Directive
(LVD) 73/23/EEC can be identified by the CE Mark on the rear of the unit. The
testing has demonstrated compliance with the following directives:
LVD, 73/23/EEC
EMC, 89/336/EEC
For any additional information, refer to the Declaration of Conformity that
shipped with the unit.

WEEE/RoHS

This product is required to comply with the European Union's Waste Electrical
& Electronic Equipment (WEEE) Directive 2002/96/EC. It is marked with the
following symbol:
Thermo Fisher Scientific has contracted with one or more recycling/disposal
companies in each EU Member State, and this product should be disposed of or
recycled through them. Further information on Thermo Fisher Scientific's
compliance with these Directives, the recyclers in your country, and information
on Thermo Scientific products which may assist the detection of substances
subject to the RoHS Directive are available at: www.thermo.com/WEEERoHS

Unpacking

Retain all cartons and packing material until the unit is operated and found to
be in good condition. If the unit shows external or internal damage contact the
transportation company and file a damage claim. Under ICC regulations, this is
your responsibility.
Out of Box Failure
An Out of Box Failure is defined as any product that fails to operate in con-
formance with sellers published specifications at initial power up. The unit must
be installed in accordance with manufacturer's recommended operating
conditions within 30 days of shipment from the seller.
Any product meeting the definition of an Out of Box Failure must be packed and
shipped back in the original packaging to Thermo Fisher Scientific for replace-
ment with a new unit; Seller to pay the cost of shipping. Customer must receive
a Return Material Authorization (RMA) from Thermo Fisher prior to shipping the
unit.
Preface
Complies with IEC/EN61010-1
IEC/EN61326-1
- 2 -