Checking And Topping Up The Front Brake Fluid; Bleeding The Front Brake Fluid - SHERCO TY 125 4T Owner's Manual

Checking and topping up the front brake fluid

A

Bleeding the front brake fluid

C
B
WARNING
Brake fluid is highly corrosive, therefore remove any spillage that may have come into contact with
parts of the motorbike.
54 54
Maintenance processes
The front brake reservoir is located next to the
brake lever. It is fitted with an inspection window for
checking the fluid level.
To inspect it correctly, make sure the motorcycle is
in an upright position.
To top up the fluid:
Type of brake fluid: DOT4.
The brake fluid level must be between 3 and 4 mm
from the top edge.
To bleed the front brake system:
A
Place a cloth under the bleed nipple to absorb the
fluid.
WARNING
- Remove the two screws
cover.
- Remove the internal rubber.
- Top up the fluid.
WARNING
- Remove the reservoir cover (see previous section).
- Remove the black protective cap
- Press in the front brake lever
- Slightly loosen the protected device
black bleeding nipple positioned next to the hose
attachment.
- Repeat various times until the air has been
eliminated from the circuit.
- Refit the black protective cap
- Refit the reservoir rubber and cover.
TIP
from the reservoir
A
.
A
and hold it in.
B
C with the
A .