Mitsubishi Electric MELSERVO-JE MR-JE-70A Instruction Manual page 20

1. FUNCTIONS AND CONFIGURATION
(2) MR-JE-200A or more
(6)
(7)
Side
(8)
(9)
(1)
(2)
(3)
(4)
(5)
Bottom
(10)
No. Name/Application
Display
(1)
The 5-digit, 7-segment LED shows the servo status
and the alarm number.
Operation section
Used to perform status display, diagnostic, alarm,
and parameter setting operations. Push the "MODE"
and "SET" buttons at the same time for 3 s or more
to switch to the one-touch tuning mode.
(2)
USB communication connector (CN3)
(3)
Connect with the personal computer.
I/O signal connector (CN1)
Digital I/O signal, analog input signal, and analog
(4)
monitor output are connected.
Encoder connector (CN2)
(5)
Used to connect the servo motor encoder.
Power connector (CNP1)
Input power supply and regenerative option are
(6)
connected.
Rating plate
(7)
Servo motor power connector (CNP2)
Connect the servo motor.
(8)
Charge lamp
(9)
When the main circuit is charged, this will light up.
While this lamp is lit, do not reconnect the cables.
Protective earth (PE) terminal
Grounding terminal
(10)
1 - 9
Used to change the mode.
Used to change the
display or data in each
mode.
Used to set data.
To the one-touch tuning
mode
Detailed
explanati
on
Section
4.5
Section
4.5
Section
6.2
Section
11.4
Section
3.2
Section
3.4
Section
3.4
Section
3.1
Section
3.3
Section
1.6
Section
3.1
Section
3.3
Section
3.1
Section
3.3