Set Up An Iptv Port To Lease An Intranet Port - NETGEAR Orbi RBR50 User Manual

A login window opens.
3. Enter the Orbi admin user name and password.
The user name is admin. The password is the one that you specified the first time that you logged in.
The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > VLAN/Bridge Settings.
The VLAN / Bridge Settings page displays.
5. Select the Enable VLAN/Bridge Group check box.
The page expands.
6. Select the By VLAN tag group radio button.
The section expands.
7. Click the Add button.
The Add VLAN Rule page displays.
8. Specify the settings as described in the following table.
Field
Name
VLAN ID
Priority
Select the check box for a wired Ethernet port.
If your device is connected to an Ethernet port on the router, select the Ethernet port check box that corresponds
to the Ethernet port on the router to which the device is connected.
You must select at least one Ethernet port. You can select more than one port.
9. Click the Add button.
The VLAN tag group is added.
10. Click the Apply button.
Your settings are saved.

Set Up an IPTV Port to Lease an Intranet Port

You can set up the router to create an Internet Protocol television (IPTV) port that can lease an IP address
from your IPTV service provider. Use this feature only if you subscribe to an IPTV service and your IPTV
service requires an intranet address.
Some IPTV ports cannot work behind Network Address Translation (NAT) because the IPTV port requires
an IP address within the Internet service provider's network (intranet address).You can set up a bridge
connection from the WAN to one of the LAN ports. When IPTV is connected through WiFi, the home router
Orbi WiFi System
Description
Enter a name for the VLAN tag group.
The name can be up to 10 characters.
Enter a value from 1 to 4094.
Enter a value from 0 to 7.
Specify Network Settings
82