Change The Mtu Size - NETGEAR Orbi RBR50 User Manual

The page adjusts.
The router automatically detects the information in the following fields:
• Router's IPv6 Address on WAN. This field shows the IPv6 address that is acquired for the router's
WAN (or Internet) interface. The number after the slash (/) is the length of the prefix, which is also
indicated by the underline (_) under the IPv6 address. If no address is acquired, the field displays
Not Available.
• Router's IPv6 Address on LAN. This field shows the IPv6 address that is acquired for the router's
LAN interface. The number after the slash (/) is the length of the prefix, which is also indicated by
the underline (_) under the IPv6 address. If no address is acquired, the field displays Not Available.
6. In the Login field, enter the login information for the ISP connection.
This is usually the name that you use in your email address. For example, if your main mail account is
JerAB@ISP.com, you would type JerAB in this field. Some ISPs (like Mindspring, Earthlink, and T-DSL)
require that you use your full email address when you log in. If your ISP requires your full email address,
type it in this field.
7. In the Password field, enter the password for the ISP connection.
8. In the Service Name field, enter a service name.
If your ISP did not provide a service name, leave this field blank.
Note The default setting of the Connection Mode field is Always On to provide a steady
IPv6 connection. The router never terminates the connection. If the connection is
terminated, for example, when the modem is turned off, the router attempts to
reestablish the connection immediately after the PPPoE connection becomes available
again.
9. Select an IPv6 Domain Name Server (DNS) Address radio button:
• Get Automatically from ISP. Your ISP uses DHCP to assign your DNS servers. Your ISP
automatically assigns this address.
• Use These DNS Servers. If you know that your ISP requires specific servers, select this option.
Enter the IP address of your ISP's primary DNS server. If a secondary DNS server address is
available, enter it also.
10. (Optional) Select the Use This Interface ID check box and specify the interface ID that you want to be
used for the IPv6 address of the router's LAN interface.
If you do not specify an ID here, the router generates one automatically from its MAC address.
11. Click the Apply button.
Your settings are saved.

Change the MTU Size

The maximum transmission unit (MTU) is the largest data packet a network device transmits. When one
network device communicates across the Internet with another, the data packets travel through many devices
Orbi WiFi System
Specify Your Internet Settings
48