Disable The Dhcp Server Feature In The Router - NETGEAR Orbi RBR50 User Manual

To use the router as a DHCP server and specify the pool of IP addresses that the router
assigns:
1. Launch a web browser from a computer or mobile device that is connected to your Orbi network.
2. Enter orbilogin.com.
A login window opens.
3. Enter the admin user name and password.
The user name is admin. The password is the one that you specified the first time that you logged in.
The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5. If you previously disabled the DHCP server feature, select the Use Router as DHCP Server check box.
6. Specify the range of IP addresses that the router assigns:
a. In the Starting IP Address field, enter the lowest number in the range.
This IP address must be in the same subnet as the router. The default starting IP address is
192.168.1.2.
b. In the Ending IP Address field, enter the number at the end of the range of IP addresses.
This IP address must be in the same subnet as the router. The default ending IP address is
192.168.1.254.
7. Click the Apply button.
Your settings are saved.
The router delivers the following parameters to any LAN device that requests DHCP:
• An IP address from the range that you defined
• Subnet mask
• Gateway IP address (the router's LAN IP address)
• DNS server IP address (the router's LAN IP address)

Disable the DHCP Server Feature in the Router

By default, the router acts as a DHCP server. The router assigns IP, DNS server, and default gateway
addresses to all computers connected to the LAN. The assigned default gateway address is the LAN address
of the router.
You can use another device on your network as the DHCP server, or specify the network settings of all your
computers.
Orbi WiFi System
Specify Network Settings
70