Engine Stopping - Perkins 402D-05 Operation And Maintenance Manual

34
Operation Section

Engine Stopping

Engine Stopping
Stopping the Engine
Stopping the engine immediately after it has been
working under load, can result in overheating and ac-
celerated wear of the engine components.
Avoid accelerating the engine prior to shutting it down.
Avoiding hot engine shutdowns will maximize tur-
bocharger shaft and bearing life.
Note: Individual applications will have different
control systems. Ensure that the shutoff procedures
are understood. Use the following general guidelines
in order to stop the engine.
1. Remove the load from the engine. Reduce the
engine speed (rpm) to low idle. Allow the engine
to idle for five minutes in order to cool the engine.
2. Stop the engine after the cool down period
according to the shutoff system on the engine and
turn the ignition key switch to the OFF position.
If necessary, refer to the instructions that are
provided by the OEM.
Emergency Stopping
Emergency shutoff controls are for EMERGENCY use
ONLY. DO NOT use emergency shutoff devices or
controls for normal stopping procedure.
The OEM may have equipped the application with
an emergency stop button. For more information
about the emergency stop button, refer to the OEM
information.
Ensure that any components for the external system
that support the engine operation are secured after
the engine is stopped.
This document is printed from SPI². Not for RESALE
i02334873
NOTICE
i01903586
NOTICE
After Stopping Engine
Note: Before you check the engine oil, do not operate
the engine for at least 10 minutes in order to allow
the engine oil to return to the oil pan.
•
Check the crankcase oil level. Maintain the oil level
between the "MIN" mark and the "MAX" mark on
the engine oil level gauge.
•
If necessary, perform minor adjustments. Repair
any leaks and tighten any loose bolts.
• If the engine is equipped with a service hour meter,
note the reading. Perform the maintenance that
is in the Operation and Maintenance Manual,
"Maintenance Interval Schedule".
•
Fill the fuel tank in order to help prevent
accumulation of moisture in the fuel. Do not overfill
the fuel tank.
NOTICE
Only use antifreeze/coolant mixtures recommended in
the Refill Capacities and Recommendations topic that
is in this Operation and Maintenance Manual. Failure
to do so can cause engine damage.
•
Allow the engine to cool. Check the coolant level.
•
If freezing temperatures are expected, check
the coolant for correct antifreeze protection. The
cooling system must be protected against freezing
to the lowest expected outside temperature. Add
the correct coolant/water mixture, if necessary.
• Perform all required periodic maintenance on all
driven equipment. This maintenance is outlined in
the instructions from the OEM.
SEBU8311-02
i03756631