Fuel Filter With Canister - Perkins 402D-05 Operation And Maintenance Manual

SEBU8311-02
Note: Do not operate the starting motor for more
than 15 seconds. If the engine does not start after 15
seconds, stop and wait for 30 seconds before trying
again.
Fuel System Filter - Replace
Fuel leaked or spilled onto hot surfaces or elec-
trical components can cause a fire. To help pre-
vent possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over discon-
nected fuel system component.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting, and repair of the product. Be prepared
to collect the fluid with suitable containers before
opening any compartment or disassembling any com-
ponent containing fluids.
Dispose of all fluids according to local regulations and
mandates.

Fuel Filter with Canister

1. Close the fuel supply valve.
This document is printed from SPI². Not for RESALE
i02608681
NOTICE
NOTICE
Fuel System Filter - Replace
Illustration 55
Typical example
2. Clean the outside of the fuel filter assembly (1).
3. Remove setscrew (2).
4. Remove the canister (3). Ensure that any fluid is
drained into a suitable container.
Illustration 56
Typical example
5. Assemble the following items: seals (8), seal (7),
canister (3), and bowl (10). Place washer (5) and
seal (6) on setscrew (2).
6. Fasten the assembly to the fuel filter base with
setscrew (2).
83
Maintenance Section
g01307792
g01334877