Omron SYSMAC C200H-CT001-V1 Operation Manual page 68

Preset Mode
Outputs
54
Word Bit
n 00 START command (The START command is effective only
when pin 4 on the back-panel DIP switch is turned OFF. If pin
4 is ON, control input IN2 is used to start and stop the
Counter Unit.)
01 TRANSFER DATA command
02 ENABLE OUTPUT command
03 Not used.
04 CHANGE PRESET command
05 READ ERROR command
06 RESET COUNTER command
07 ENABLE FORCED OUTPUT command
08 Output #0 force bit
09 Output #1 force bit
10 Output #2 force bit
11 Output #3 force bit
12 Output #4 force bit
13 Output #5 force bit
14 Output #6 force bit
15 Output #7 force bit
−
n+1 Not used.
07 04
−
Preset number, 2 digits, between 00 and 19
15 08
−
n+2 TRANSFER DATA beginning word number, 4 digits
15 00
−
n+3 TRANSFER DATA data area, 0 through 4
03 00
−
Not used. (Set to 0.)
07 04
−
Number of transfers, 1 through 3
15 08
Section 4-3
Function