Lines Per Inch Setting (Line Spacing) - Microplex SOLID 166E Operator's Manual

86 Panel Functions
_______________________________________________________________________________________________

5.26. Lines per Inch Setting (Line Spacing)

________________________________________________________________________________________________
MICROPLEX
This function sets the number of lines per inch. This setting is effective
only in case of using the printer as a line printer.
With a small number of lines per inch, line spacing will be relatively
large. (Ref. IDOL Programming Manual).
Panel display
[SOLID 166E ]
[Menu Level 1 ]
( ( (
[Page Menu ]
[Font Number ]
( ( (
[Line Spacing ]
[Digit4 006.5 ]
( ( (
[Digit1 010.0 ]
[Save as Setup? ]
Operator's Manual SOLID 166E
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until [Page
Menu ] is displayed.
Press the NEXT or PREVIOUS key until [Line
Spacing ] is displayed.
6.5 lpi = currently set value.
(lines per inch).
Pressing the PLUS or MINUS key changes the
value of the current digit (Digit 4 = left
position, in this example: 0). Pressing the
NEXT key moves you to the next digit (the
PREVIOUS key moves you back, if need be).
You can use the number block to set the
function value, too.
The number of lines per inch was increased
to 10 lpi.
In addition this new value can be saved as
setup value (using the ENTER key), before the
printer is turned ON LINE again.
Edition 1.1