Navigating The Menu Windows - Hach LDO User Manual

User Interface and Navigation
Figure 9 Main Menu
1
1. Display Area
2.
BACK
3.
FORWARD
4. –confirms the entry or selection.
ENTER
5. –changes to the display of measured values. The pop-up toolbar cannot open from the menu window. To view the
HOME
Main Menu from this display, touch the Home button and then the bottom of the screen.
6. –scrolls up
UP
7. –scrolls down
DOWN

4.2.1.3 Navigating the Menu Windows

18
2 3
MENU
SENSOR STATUS
SENSOR SETUP
SYSTEM SETUP
TEST/MAINT
To view a menu item, touch the menu item or use the
item. The menu item remains highlighted for approximately 4 seconds after it is selected.
To view the highlighted command, select the area to the left of the menu item or select the
button.
ENTER
A "+" next to a menu command indicates there is a submenu. Touch the "+" to view the
submenu. An "i" next to a menu command indicates it is information only.
If a menu item is editable, highlight the item and touch the far-left part of the menu item
until it is highlighted and press
displayed to change an entry
(Figure 12 on page 20).
Messages are displayed in the message window
If an entry is incorrect, repeat the entry with the correct values. If the entry is outside the
working range, a correction to the entry is made automatically.
4 5
UP
or double-tap the highlighted item. A keypad will be
ENTER
(Figure 11 on page 19) or a list box will be displayed
(Figure 13 on page
6
7
and keys to highlight the
DOWN
20).