Connecting The Sensor To The Sc1000; Connecting The Sensor Using The Quick-Connect Fittings; Installing The Sensor In The Sample Stream - Hach LDO User Manual

3.2 Connecting the Sensor to the sc1000

3.2.1 Connecting the Sensor using the Quick-connect Fittings

3.3 Installing the Sensor in the Sample Stream

1. Unscrew the connector cap from the controller. Retain the connector cap to seal the
connector opening in case the sensor must be removed.
2. Push the connector into the socket.
3. Hand-tighten the union nut.
Note: Do not use the middle connection for the sensors as this is reserved for the display module.
To install the LDO in a sample stream, it is recommended to use either the optional pole
mount (Cat. No. 5794400) or ball float mount (Cat. No. 5794300) as shown in
Please refer to the instruction sheets provided with these mounting kits for more detailed
information.
Installation
Figure 5.
13