Installation Of The Zoom Body; Attaching An Objective(S) - Nikon Multizoom AZ100 Instruction Manual

Installation of the Zoom Body

Attach the AZ100 zoom body to the focusing mount adapter.
1. Remove the two clamp screw covers on the right of
the zoom body and sufficiently loosen the two
clamp screws with the hexagonal wrench (size:
4mm) provided with the product.
2. Align the dovetail groove of the zoom body with the
dovetail joint of the focusing mount adapter and
slide down the zoom body.
Be sure to slide down the zoom body as far as it goes.
3. Tighten the two clamp screws to secure the zoom
body and attach the clamp screw covers.

Attaching an Objective(s)

Screw an objective (objectives) into the single or triple
nosepiece. Raise the elevating section of the stand and lower
the stage. And then screw the objective into the attachment
hole. Be careful to avoid bumping the objective.
The objectives below are applicable.
Objective Magnification
AZ-Plan Apo 0.5x
AZ-Plan Apo 1x
AZ-Plan Fluor 2x
AZ-Plan Apo 4x
AZ-Plan Fluor 5x
* The color codes are used to select the DIC slider for the DIC
microscopy or to select the condenser or the filters for the
diascopic stand.
Chapter 4 Aseembly
Working
distance
0.5 54
1 35
2 45
4 20
5 15
Zoom body (and single nosepiece)
Dovetail joint
* For the single nosepiece configuration,
attach the nosepiece to the zoom body
before this step.
Screw the
Color code *
objective into the
attachment hole.
Silver
Objective
Gold
White
Red
Orange
20
Clamp screw
Attach the adapter
ON
OFF with aligning the
CLIC K
dovetail groove with
the dovetail joint.
Focusing mount
adapter
Zoom body installation
ON
OFF
CLIC K
Attaching an objective