Operation Guide - Stryker Power-LOAD User Setup Manual

OPERATING GUIDELINES
Check Power-LOAD for proper functionality before starting each shift (the lifting arms should slightly raise the cot
as the cot is unlocked, check the battery power level, etc.). If the unit does not seem to be operating properly,
remove the vehicle from service to diagnose and repair Power-LOAD.
Do not operate Power-LOAD with weights greater than 700 lb (318 kg), which includes patient weight and
accessories. The safe working load of Power-LOAD is 870 lb (395 kg), which includes the weight of the cot.
Do not turn off the main power button during normal use as it will prevent battery charging.
Do not drive the vehicle with the trolley in the mid position. This position does not lock and is not intended for
driving.
Power-LOAD is only an assisting device. Operators are responsible for evaluating each situation to determine how
to distribute and lift the weight being transported. Always use both hands when handling the cot.
When handling weights over 400 lb (181 kg), ensure there are enough operators to handle the forces required
for loading/unloading. To increase safety, users should attempt to perform loading/unloading on flat surfaces.
Keep hands and extremities clear of the Power-LOAD trolley lifting arms and the cot base during powered loading
and unloading.
Use caution when operating Power-LOAD in adverse weather conditions (for example, rain, ice, snow) to avoid
operator and/or patient injury.
Operate Power-LOAD with the vehicle on a flat surface, if possible.
If you are unable to unload an occupied cot from the vehicle patient compartment, use a backboard to unload the
patient.
Stryker recommends periodic training (at least once per year) on manual backup procedures. See "Unloading
a Cot From a Vehicle Manually (Power-LOAD Power Loss or System Error)" on
a Vehicle Manually (Power-LOAD Power Loss or System Error)" on
Manually" on page 62
Manually (Power-PRO Power Loss)" on
WARNING
Improper usage of the Power-LOAD system or any accessory can cause injury to the patient or operator. Operate
the Power-LOAD system and accessories only as described in the manuals.
Failure to ensure proper Power-LOAD functionality prior to use may result in patient and/or operator injury.
Use caution while moving around in the vehicle patient compartment to avoid tripping on Power-LOAD.
To avoid the risk of operator and/or patient injury, use caution when operating Power-LOAD in adverse weather
conditions (for example, rain, ice, snow).
Entanglement in powered cot and/or Power-LOAD mechanisms can cause serious injury. Operate the cot and/or
Power-LOAD only when all persons are clear of the mechanisms.
Practice loading and unloading the cot with Power-LOAD until operation of the product is fully understood. Improper
use can cause injury.
Do not allow untrained personnel to assist in the operation of Power-LOAD. Untrained technicians/personnel can
cause injury to the patient or themselves.
To reduce the risk of patient injury and/or equipment damage, do not drive the vehicle with the trolley in the mid
position. This position does not lock and is not intended for driving.
Power-LOAD is only an assisting device. Operators are responsible for evaluating each situation to determine how
to distribute and lift the weight being transported. Always use both hands when handling the cot.
When handling weights over 400 lb (181 kg), ensure there are enough operators to handle the forces required
for loading/unloading. To increase safety, users should attempt to perform loading/unloading on flat surfaces.
Keep hands and extremities clear of the Power-LOAD trolley lifting arms and the cot base during powered loading
and unloading.
CAUTION
Possible fire hazard when used with oxygen administering equipment of other than nasal, mask or 1/2 bed length tent
type. Oxygen tent should not extend below mattress support level nor be used around Power-LOAD or a Power-LOAD
compatible cot.
Return To Table of Contents
48

Operation Guide

"Unloading a Cot from a Vehicle Manually" on
page 64.
6390-009-001 REV B
page 59, "Loading a Cot into
page 61, "Unloading a Cot from a Vehicle
page 62, "Loading a Cot into a Vehicle
www.stryker.com