Int_Chan_3 - ICP DAS USA PIO-D48 User Manual

PIO-D48 Series Card
48-channel OPTO-22 Compatible DIO Board

2.7.5 INT_CHAN_3

INT_CHAN_3 should normally be fixed in a low-level state and generate a high_pulse to interrupt
the PC.
Cin1 can be 2M/32768Hz programmable as is given below: (Refer to
CTRL_D0=0  Cin1=2 M clock source
CTRL_D0=1  Cin1=32768 Hz clock source
EN3 can be used to enable/disable the INT_CHAN_3 as follows: (Refer to
EN3=0  INT_CHAN_3= Disabled
EN3=1  INT_CHAN_3= Enabled
INV3 can be used to invert/non-invert the Cout0 as follows: (Refer to
INV2=3  INT_CHAN_3=invert (Cout2)
INV2=3  INT_CHAN_3=non-invert (Cout2)
Refer to the following demo program for more information:
Operating System: DOS
DEMO4.C
Note: Refer to Sec. 2.7.2 for active high-pulse generation.
For INT_CHAN_3 only (Cout2)
User Manual/Ver. 3.4/Aug. 2015/PMH-006-34/Page: 19
Figure 2-8
Sec. 6.3.9)
Sec. 6.3.4)
Sec. 6.3.6)