Setup : Menu Operation - GRAPHTEC GL840 Quick Start Up Manual

2. Setup : Menu Operation

Select the setting for only the channels being used. Make sure to turn off unused
channels. It is unnecessary to change all setting from the factory default.
Basic Setup Menu Operation
The , [ENTER], and [QUIT] keys are used to set the condition on the setup menu.
The current position of the cursor on the setup menu is displayed in green.
Use the
position, a selection menu or a box of entering value for selected item is displayed.
If you push the [QUIT] key, the screen closes and the settings are canceled.
•
Examples of selection menu operations (AMP screen)
1. Use the keys to move
the cursor to the Input
parameter of CH 1 and then
push the [ENTER] key.
(Note: Select "DC" for voltage measurement, and "Temperature" for temperature measurement.)
Key Pointers
keys to move the cursor. When the [ENTER] key is pushed at the cursor
2. A selection menu is displayed
when the [ENTER] key is
pushed. Use the
to select "TEMP."
1. Push the [MENU] key to display the setup menu screen.
2. Set Input to "TEMP" and Sensor to "TC-T" for CH1,
and set Input to "DC" and Range to "1V" for CH2.
(1) Move the cursor to CH1 "Sensor" and select "TC-T" and then move to
"Range" and select "100°C" .
(2) In the same manner, move the cursor to CH2 "Input" and select "DC" and
then move to "Range" and select "1V."
3. Select "Off" for all the other channels.
(1) Using the procedure described above, select "Off" for CH 3 to CH 10.
Use the [CH GROUP] key to switch to the CH11 to CH20 group.
3. Push the [ENTER] key to
confirm your selection.
and keys
Select with ,
and [ENTER] key.
12