GRAPHTEC GL840 Quick Start Up Manual page 9

4
. MENU
Push the [MENU] key to open a setup menu. As you push the setup screen tabs
change in the sequence shown below as you push the [MENU] key.
AMP
DATA
TRIG
I/F
WLAN
OTHER
5
. QUIT (LOCAL)
Push the [QUIT] key to cancel the settings and return to default status.
When you cancel the connection on the application, the GL840 is automatically
sent back to local mode. If local mode is not entered, push the[QUIT] key.
6
. Keys (DIRECTION KEYS)
Direction key are used to select menu setup items, to make span settings in the
digital display area, or to move the cursors during a data replay operation.
7
. ENTER
Push the [ENTER] key to submit the setting and to confirm your settings.
8
.
Fast forward and rewind keys are used to move the cursor quickly during replay or
change operation. Hold down both keys simultaneously for at least two seconds to
lock the key buttons. To cancel key lock status, push them again for at least two
seconds.
The key lock status can be confirmed by the status of the key lock lamp on the
monitor.
* Pushing these keys simultaneously with the
for the key lock operation.
[Menu] Sequence
•
AMP Settings
Set the input, range, filter , scaling, and other channel based
settings.
•
Data Settings
Set sampling interval, recording, and calculations during data
record.
•
Trigger Settings
Specify recording start and stop conditions, and alarm conditions.
•
Interface Settings
Set the device ID in the USB and the IP address for the LAN.
•
Wireless LAN setting
Set the connection to the wireless LAN after the wireless unit is
installed.
•
Other Settings
Set the screen brightness, background color, language and etc.
Keys (KEY LOCK)
key + ENTER +
(displayed when the option is installed)
key enables password protection
8