Table of Contents
Advertisement
2.5
Hardware Installation
Warning! TURN OFF your PC power supply whenever you install or remove the PCL-730
or connect and disconnect cables.
1.
Turn the computer off. Turn the power off to any peripheral devices such as
printers and monitors.
2.
Disconnect the power cord and any other cables from the back of the computer.
3.
Remove the system unit cover (see the user's guide for your chassis if neces-
sary).
4.
Locate the expansion slots at the rear of the unit and choose any unused slot.
5.
Remove the screw that secures the expansion slot cover to the system unit.
Save the screw to secure the interface card retaining bracket.
6.
Carefully grasp the upper edge of the PCL-730 card. Align the hole in the retain-
ing bracket with the hole on top of the expansion slot and align the gold striped
edge connector with the expansion slot socket. Press the board firmly into the
socket.
7.
Secure the PCL-730 using the screw you removed in Step 5.
8.
Attach any accessories (using 20 pin flat cables, a DB-37 cable, etc.) to the
PCL-730.
9.
Replace the system unit cover. Connect the cables you removed in Step 2. Turn
the computer power on.
PCL-730 User Manual
10
Advertisement
Table of Contents
