Accessing The Boiler; Flushing Out The Primary Side - PENSOTTI PNCC-32N Instruction Manual

6.3 Accessing the boiler

All maintenance operations require one or more of the
boiler casing panels to be removed.
The side panels can only be removed after the front
panel has been removed.
Front panel:

Remove the fixing screws at the lower edge of the
front panel.

Grasp the lower part of the panel and pull it
outwards (see fig. 1) and then up (see fig. 2).
Left and right side panel:

Remove the fixing screws at the front and lower
edge of the side panel to remove.

Grasp the bottom of the panel, move it sideways
and then upwards to remove it.
To access the electrical connections of the control
panel, proceed as follows:

Switch off the power supply at the main switch.
 Remove the front panel (see fig. 1 and fig. 2).
 Grasp the left and right control panel support
brackets (see fig. 5) and pull them outwards, at the
same time rotating the panel downwards.
 Unscrew the four fixing screws (see fig. 6) and
remove the panel back piece.

6.4 Flushing out the primary side

Fill the boiler as per the filling instructions.
Using a drain off cock on the lowest point of
the system allow the water to drain from the
system and boiler.
In order to flush the system correctly, turn off
all radiators or fan coils. Open the filling loop
and drain cock simultaneously and allow the water to flow through the boiler.
Open each individual radiator or fan coil, allowing water to flow through. Then turn that radiator or fan coil off
and repeat for all radiators or fan coil on the system.
Turn off the filling loop and close the drain cock open all radiators and open the filling valve to fill the system.
Continue to fill the system until the pressure gauge reads in the Green section of the gauge 14.5 psi.
In order to safeguard all waterside components the supplied Fernox Commissioning Kit must be used in its
entirety.
INSTALLATION INSTRUCTIONS
Fig. 1
1
2
2
Fig. 2
3
1
66