Battery Low Alarm; Back To Factory Setting; Antenna; Using Condition - Carscop CCTR-800G User Manual

 We recommend using OEM charger to recharge the tracker. this tracker use the 5V DC voltage to
recharge, so too high voltage or AC voltage may damage the tracker or even cause accidents.
 Use the car adapter or home charger or PC USB to recharge the tracker: insert the USB wire into
the charging port bedside the tracker, the other side connect to the home or car charger, If the
LED on the charger is RED, it means it is recharging, if the LED on the charger is GREEN, it
means the recharging is finished. This will take about 5-10 hours.

5. Battery Low Alarm

When the battery voltage in the tracker is too low, the tracker GREEN LED will flash 3 or 4 times, and send
battery low alarm information to authorized number, and later if the battery power is too low, it will power off
automatically.
6. Back to Factory Setting (Default Setting)
Sending SMS "FACTORY*123456" to the tracker SIM card number, the tracker , the tracker will delete all
the user setting (authorized number / Alarm setting / Password / APN / Working mode etc), reset to factory
default setting, and then re-power on.Also you can use a other way back to factory setting:turn off the
tracker,then press the "ON/OFF" button till the led flash faster finished, then release the button,the tracker will
re-power on.

7. Antenna

 The Antenna of GSM/WCDMA and GPS are built in the tracker.
 Pleas leave the tracker away from big metal, this will reduce the GSM/WCDMA and GPS signal.

8. Using Condition

The working temperature is -20
reach the standard level, the storage temperature can reach to -40
Simply Using
1. First to buy a 2G GSM or 3G WCDMA mobile phone SIM card and enable data service, order a data
package (Normally will use about 10M-30M GPRS data every month), install in the tracker, please refer the
above Before Using1.
C to 60 C, over this range the specification of the tracker maybe can not
0 0
4
- -
0 C to 80 0 C.