Cleaning And Flushing - Honda BF75D Owner's Manual

Thoroughly clean and flush the
outboard motor with fresh water after
operating in dirty water or salt water.
Do not apply water or corrosion
inhibitor directly to the electrical
components under the engine cover,
such as the O2 sensor. If water or
corrosion inhibitor penetrates
these components, they may be
damaged. Before applying a
corrosion inhibitor, cover the O2
sensor (and belt, if applicable) with
a protective material to prevent
damage.
Shut off the engine before
performing the cleaning and flushing.
1. Clean and wash the outside of the
outboard motor with fresh water.
FLUSH PORT
CONNECTOR
FLUSH PORT
CONNECTOR
2. Disconnect the flush port
connector.
3. Screw the flush port connector
onto the garden hose.
11.

CLEANING AND FLUSHING

4. Turn on the fresh water supply and
flush the outboard motor for at
least 10 minutes.
5. After flushing, disconnect the
garden hose and reconnect the
flush port connector.
When using the water hose joint:
WATER HOSE JOINT
(commercially available)
FLUSH PORT
CONNECTOR
WATER HOSE
115