Cleaning And Flushing - Honda BF40D Manual

32ZZ4641.book 127 ページ ２０１８年８月３日 金曜日 午前９時４４分
After each use in salt water or dirty
water, thoroughly clean and flush the
outboard motor with fresh water.
Do not apply water or corrosion
inhibitor directly to the electrical
components under the engine
cover, such as the O2 sensor. If
water or corrosion inhibitor
penetrates this component, it may
be damaged. Before applying a
corrosion inhibitor, cover the O2
sensor with a protective material to
prevent damage.
Shut off the engine before performing
the cleaning and flushing.
1. Disconnect the fuel line from the
outboard motor.
2. Tilt down the outboard motor.
3. Clean and wash the outside of the
outboard motor with fresh water.

11. CLEANING AND FLUSHING

FLUSH PORT
CONNECTOR
FLUSH PORT
CONNECTOR
4. Disconnect the flush port
connector.
5. Screw the flush port connector onto
the garden hose.
6. Turn on the fresh water supply and
flush the outboard motor for at
least 10 minutes.
7. After flushing, disconnect the
garden hose and reconnect the flush
port connector.
8. Tilt up the outboard motor and
move the tilt lock lever to the
LOCK position.
• When using the water hose joint:
WATER HOSE JOINT
(commercially available)
FLUSH PORT WATER HOSE
CONNECTOR
127