Location; Installation Height - Honda BF75D Owner's Manual

INSTALLATION

Location

CENTER LINE
Install the outboard motor at the stern,
at the center line of the boat.
44

Installation Height

BOAT TRANSOM
HEIGHT
IDLE
PORT
± 25 mm
( 1 in) ±
TRANSOM HEIGHT
ANTICAVITATION PLATE
The anticavitation plate of the
outboard motor should be
( 1 in) below the bottom of the boat. ±
The correct dimensions differ
according to the type of the boats and
the configuration of the bottom of
the boats. Follow the manufacture's
recommended installation height.
IDLE
PORT
150 mm
(5.9 in)
or more
WATER LEVEL
The water level must be at least
± 25 mm 100 mm (4 in) above the
anticavitation plate, otherwise
the water pump may not receive
sufficient cooling water, and the
engine will overheat.
Adverse effect to the engine can
occur if the installation position
of the outboard motor is too low.
Trim/tilt down the outboard
motor with the boat fully loaded
and stop the engine. Check that
the idle port is 150 mm (5.9 in)
or more above the water level.
FULLY
TRIM/TILT
DOWN