Disconnect Or Remove The Fan - Welch Allyn Connex Service Manual

84 Section A
2. Remove the light bar and cover.
3. Remove the light bar from the light-bar cover.
4. Disconnect the light-bar harness from the light-bar board.
5. If replacing the light-bar board, remove the light-bar board from the light bar by
sliding the board out from the connector end.
Reassembly notes
• Insert the light-bar board by placing the end without the connector into the open end
of the light bar.
• Slide the light-bar board into the light bar until the connector end is flush with the
end of the light bar.
• Feed the light-bar harness wires through the slot so they do not get pinched during
reassembly.

Disconnect or remove the fan

Complete the following preliminary steps:
• Power down the system and disconnect the AC power cord.
• Remove the system from the wall and remove the battery.
• Remove the handle module assembly.
®
Welch Allyn Connex Integrated Wall System