Final Tests; Maintenance - GiBiDi PASS 600 Instructions For Installations

14
UK
MANUAL UNLOCKING OPERATION [20]
You can manually operate the gate if a problem occurs or if the power supply fails. To manually operate the gate,
carry out the following procedure:
r
Rotate the cover
Ÿ
out a few millimeters by a spring. Then completely turn the handle
open and close the gate.
To automatically reset it, turn the handle
Ÿ
(to the left), and then remove it.
e
NOTE: If the key is not completely pushed forward, it will not turn and cannot be removed. The handle
be locked in the manual position by following the above procedure with the key

FINAL TESTS

Close the gearmotor casing. Power the system and run a complete opening and closing cycle checking that:
Ÿ
the gate moves smoothly;
Ÿ
the safety devices function properly;
Ÿ
the foundation plate is firmly in place;
Ÿ
the gate assembly is in compliance with the current EN 12453 EN 12445 standards;
For further details and information on the reference standards, visit our site: www.gibidi.com

MAINTENANCE

Periodically check the gate structure, in particular:
check perfect functioning of the rails;
Ÿ
check that the rack has not lowered with the weight of the gate, since it would weigh down on the gearmotor. Should
Ÿ
this be the case, raise the rack and retighten the screws lower down in the slot, or lower the gearmotor using the
adjusting nuts [ 8];
every 6 months check good functioning of the safety devices;
Ÿ
unlock the operator and check that there are no points of friction along the entire travel of the gate;
Ÿ
Ÿ check proper functioning of the unlocking device (see the relative paragraph);
Ÿ check that there is no dirt or fragments on the pinion.
Ÿ
Gi.Bi.Di. S.r.l. reserves the right to change the technical data without prior notice in relation to product development.
DISPOSAL
GI.BI.DI. advises recycling the plastic components and to dispose of them at special authorised centres
for electronic components thus protecting the environment from polluting substances.
e
, insert the key , and turn it clockwise (to the right) without forcing it. The key
q
to its initial position, push the key
q
180° towards the left. You can now manually
e
forward, turn it counterclockwise
e
.
PASS
e
will be pushed
q
can even