Final Tests; Maintenance - GiBiDi SL 244 Instructions For Installations

SL
FITTING THE BATTERY COVER
Optional code AJ00605 (29 - 30)
1- remove the caps A – B(29);
2- cut the casing for the cables to run through C(30);
3- Insert the square nuts D(31);
4- position the battery charger cover E(31);
5- tighten the retaining screws F(31).

FINAL TESTS

Close the gearmotor casing (32).
Power the system and run a complete opening and closing cycle checking that:
• the gate moves smoothly;
• the safety devices function properly;
• the foundation plate is firmly in place;
• the gate assembly is in compliance with the current EN 12453 EN 12445 standards;
• for further details and information on the reference standards, visit our site:
www.gibidi.com

MAINTENANCE

Periodically check the gate structure, in particular:
• check perfect functioning of the rails;
• check that the rack has not lowered with the weight of the gate, since it would weigh down on the gearmotor.
Should this be the case, raise the rack and retighten the screws lower down in the slot, or lower the gearmotor
using the adjusting screws (15);
• every 6 months check good functioning of the safety devices;
• unlock the operator and check that there are no points of friction along the entire travel of the gate;
• check proper functioning of the unlocking device (see the relative paragraph);
• check that there is no dirt or fragments on the pinion.
Gi.Bi.Di. S.r.l. reserves the right to change the technical data without prior notice in relation to product development.
21
UK