Adjusting The Clutch - GiBiDi PASS 600 Instructions For Installations

PASS
FITTING THE LIMIT SWITCHES [16]
u
1-insert the nuts in the hexagonal seats on the magnet holder
2- insert the grub screw and nut
least 1-1.5 mm;
3- insert the adjusting screw and nut
e
4- assemble the bracket
NOTE: at this stage, it is sufficient to assemble the unit to then position it on the rack without having to tighten the
screws.
5- Position the complete limit switches on the rack in the appropriate positions.
NOTE: the limit switch marked on the cover with the letter "O" must be secured in correspondence to the gate-open
position and the one marked "C" in the gate-closed position [18]. To ensure this condition in applications where
the motor is installed on the "left" [18] invert the motor power cables.
Note with reference to Figure [18]
C2: Limit switch "C" Motor off during closing
C1: Limit switch "C" Deceleration start during closing
O2: Limit switch "O" Motor off during opening
O1: Limit switch "O" Deceleration start during opening
6- To fasten the limit switch, first tighten the two screws
depending on the type of rack and then act on the grub screws
WARNING: Do not overtighten the grub screws
7- Should the limit switch not yet be sufficiently integral with the rack, you can adjust it by unscrewing the screw
WARNING: Do not exceed in this adjustment since you may deform the bracket.
USING THE DECELERATION FUNCTION
If using GI.BI.DI. boards that have the deceleration control function, remember to position 2 pairs of limit switches as
shown [18].

ADJUSTING THE CLUTCH [19]

ATTENTION: Before beginning to adjust the clutch, disconnect the power supply by turning off the main switch.
Insert the size 6 Allen wrench into the socket
Ÿ
Ÿ Remember that turning the wrench clockwise increases the thrust and turning it counterclockwise decreases the
thrust.
If the shaft also rotates when you turn the Allen wrench, line the two sockets
Ÿ
on the flange). Then insert a screwdriver
q
in the magnet holder
y
in the hexagonal seat of the magnet holder
using the screws provided
t
so as not to deform the bracket.
w
.
e
and use the Allen wrench to adjust the clutch.
p
;
p
making sure that it protrudes towards the rack
r
and insert the grub screws
r
, then act on the screw
t
to securely lock the bracket to the rack.
q
p
;
t
.
y
to adjust the clamp distance
up (the one on the shaft with the one
13
UK
w
by at
y
.