Table of Contents
Advertisement
Available languages
Available languages
OPERATOR INSTALLATION
9 - Fix the front bracket to the leaf with a clamp fig.8b .
10- Use a spirit level to check that the operator is perfectly level.
11 - Remove the operator from the front and rear bracket .
12 - Fasten the front bracket .
13- Unlock the operator (see unlocking device).
14 - Fit the operator on the brackets.
15 - Manually open and close the gate to its full opening and closing travel. The gate must move smoothly without
friction and the lead nut must not reach the mechanical end-stop during opening or closing. If otherwise, adjust
the bracket positions.
It is recommended to leave at least 40-50 mm of cable free.
UNLOCKING DEVICE
If the gate needs to be operated manually because of a power failure or operator malfunctioning:
Remove the rubber plug fig.9a-9e .
Ÿ
Insert the release key to the release slot fig. 9a-9e .
Ÿ
Turn the release key as shown in fig.9b-9f .
Ÿ
Pull out the release bar and keep it pulled out fig.9c-9g .
Ÿ
Turn the release key to its original position to fix the release bar fig.9d-9h .
Ÿ
Move the gate manually only in the event of a power failure.
INSTALLING THE ELECTRIC LOCK
If you need to install an electric lock, refer to figures
1) ELECTRIC LOCK
2) ELECTRIC LOCK FASTENING PLATE
3) BUSHING
4) END-STOP FOR BUSHING
5) SPRING LATCH
6) THROUGH CYLINDER (ON REQUEST)
7) GATE
FINAL CHECKS
Power the system and run a complete opening and closing cycle checking that:
• The safety devices function properly;
• The gate moves smoothly;
• Good hold of the fastening brackets;
• That the power cable moves freely;
• The gate assembly conforms to EN 12453 and EN 12445;
• For further details and information on the reference standards, visit our site: www.gibidi.com
fig.
11 and
fig.
12 .
13
UK
Advertisement
Table of Contents
