Grassbox Assembly; Cutting Height Adjustment - Fieldmann FZR 2002-E Instruction Manual

EN 14 Assembly | Grassbox assembly | Cutting height adjustment
Attach the lower handles 7 to the pre-arranged locations on the lawnmover chassis and
secure them with the nut and washer 4+5 (A3)
Attach the upper part of the handle using the bolt, washer and nut 4+5+6. The handle is
height adjustable in two positions I and II (A4)
Note: Make sure that the cable clips 11 are used for attaching the cable to the handle.
Note: Attach the cable to the cable knee piece 3 to ensure that the cable is sufficiently
loose. (Does not apply to UK models)
Note: Make sure the cables are not entrapped during folding/unfolding the upper handles.
Do not let the handles fall down.

7. GRASSBOX ASSEMBLY

Mount the handle to the upper cover of the catcher (B1)
Connect the left and right part of the box and attch the flap to the opening of the lower part of
the box(B2)
Using clips, attach the upper part of the grassbox to the lower part, beginning from the rear
part. All clips must be correctly located. (B3)
Fitting fully assembled grassbox to the lawnmower (B4)
Lift the safety guard (B4-a)
Make sure that the discharge chute is clean and free of any debris
Attach the fully assembled grassbox 10 to locations in the rear parts of the platform as shown
in the picture (B4-b)
Attach the safety flap onto the top of the grassbox. Make sure that the grassbox is easily
attachable.
Note: If no grass collection is required, the lawnmower can be used without the grassbox
attached, with the safety guard 8 in the down position.

8. CUTTING HEIGHT ADJUSTMENT

Note: Before adjusting the height, release the switch lever 10 and wait till the engine stops.
The blades continue to rotate for a few seconds even after the machine has been switched
off and the rotating blade can cause injuries.
The cutting height can be adjusted by raising or lowering the front and rear wheels using the
small lever c1. To adjust, pull the small lever back towards you first.
This product allows for adjustment of 5 cutting heights.
FZR 2002-E