Trouble-Shooting - Fieldmann FZR 2002-E Instruction Manual

13. TROUBLE-SHOOTING

The following table presents the checks and operations you can carry out if your machine
does not work properly. If the problem is not identified/repaired, contact your service
representative.
WARNING! Before trouble shooting, switch off the equipment and unplug it from the mains.
SYMPTOM
Machine does not
work
The machine works
intermittently
ELECTRIC MOWER GARDEN
POSSIBLE CAUSE
Power supply is switched off
Defective power socket
Damaged extension cable
Defective/blown fuse
Lawnmower on long grass
Engine protection switch
activated
Safety mode activated
Damaged extension cable
Damaged internal circuitry
of the machine
Engine protection switch
activated
Safety mode activated
Trouble-shooting
CORRECTIVE ACTION
Switch on the power supply
Use another socket
Check the cable and, if damaged,
replace it
Remove the fuse
Raise the cutting height and tilt the
lawnmower
Let the engine cool down and raise
the cutting height
Let the engine cool down for a few
minutes and raise the cutting height
At this time do not operate the switch
lever 1 as this will prolong the time to
reset the safety cut out
Check the cable and, if damaged,
replace it
Contact your service representative
Let the engine cool down and raise
the cutting height. Let the engine cool
down for a few minutes and raise the
cutting height
At this time do not operate the switch
lever 1 as this will prolong the time to
reset the safety cut out
OPERATING INSTRUCTIONS
17 EN