Maintenance And Storage - Fieldmann FZR 2002-E Instruction Manual

EN 12 Safety instructions
For wheeled rotary machines, mow across the face of slopes, never up and down;
Exercise extreme caution when changing direction on slopes;
Never mow on excessively steep slopes;
Use extreme caution when reversing or pulling the machine towards you;
Stop the blade(s) if the lawnmower has to be tilted for transportation when crossing surfaces
other than grass, and when transporting the lawnmower to and from the area to be mowed;
Never operate the machine with defective guards, or without safety devices, for example
deflectors and/or grasscatchers, in place;
Start the engine carefully according to instructions and with feet well away from the blade(s);
Do not tilt the lawnmower when starting the engine except if the lawnmower has to be tilted
to start. In this case, do not tilt it more than absolutely necessary and lift only the part which is
further away from the operator;
Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at
all times;
Never pick up or carry the lawnmower while the engine is running;
Stop the engine before clearing blockages or unclogging the chute;
- before checking, cleaning, or working on the lawnmower;
- after striking a foreign object inspect the lawnmower for damage and make repairs before
restarting and operating the lawnmower;
- if the machine starts to vibrate abnormally (check immediately);
always stop the engine whenever you leave the lawnmower;

Maintenance and Storage

keep all nuts, bolts and screws tight to be sure the equipment is in good working condition;
check the grasscatcher frequently for wear and deterioration;
replace worn or damaged parts for safety;
before storing the lawnmower, clean it from grass residuals
Safety Warnings for Lawnmower Operation
Do not use the lawnmower if the cables are damaged or worn-out.
Do not connect damaged cable to the power supply and do not touch the damaged cabl
until disconnected from the power supply. Damaged cord could cause contact with energized
parts.
Do not touch the blades until the equipment is disconnected from the power supply and the
blades have completely stopped.
Keep the extension cables in safe distance from the blades. Blades could damage the cables
and cause contact with energized parts.
Disconnect the power supply (i.e. by unplugging the plug from the socket)
whenever you leave the machine unattended,
before deblocking,
FZR 2002-E