Operation; Filling - Heating - Meiko K160 Operating Instructions Manual

Operating Instructions - Control MIKE 3 - CE
Datei:BA_MIKE3-CE_KUNDE_9652929_EN_2008-06.docx
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
3.2

Operation

If the machine has been prepared for operation as described in the Operating Instructions
for the machine, it may be switched on. All the steps necessary to prepare it for operation
are described below.
Open the stop valve in the water
pipe.
The starting point is the machine when it is switched off.
The display shows:
All the operating steps described below may be available. However, not every

3.2.1 Filling - Heating

The machine's wash-tanks are filled and heated
by pressing the "Filling - Heating" key.
All doors and drains must be closed before the
machine will fill and heat. Any open doors are
indicated in the display.
"Filling-Heating
The LED of "Filling / Heating key" will flash!
key"
The display shows:
The display indicates the stage the process has reached.
The tank heating elements switch on as soon as the minimum water
level has been reached. The display shows:
(Exception: the temperature of the water entering the machine is
already at the temperature for filling the wash tank which is
programmed into the electronic system.)
As soon as all the tanks are full, the display shows:
The display shows "Heating" until the
programmed tank temperature has been reached.
After this stage the display shows:
The LED of the "Filling/Heating key" is now
illuminated permanently.
W e reserv e the right to change execution and construction!
machine has every operating step.
Update:2009-12-19 MRL
Switch on the power supply
from the building.
Machine off
Filling
Filling / Heating
WT1 45°C KSP1 80°C
Heating
WT1 45°C KSP1 80°C
Ready for operation
WT1 65°C KSP1 82°C
9652929 5/14