Stacked Module - Sanyo MCO-5M Service Manual

Stacked module

This unit can be stacked by using the stacking kit. Following shows the procedure for stacking the unit.
Consult with a Sanyo representative or agent prior to stacking procedure as such work involves dangers.
WARNING
Select a level and sturdy floor having enough strength for installation of stacked module.
Never stack 4 or more units.
Take care not to drop or tip over the unit when stacking as this can cause injury or damage of the
unit.
1. Turn off the power switch and disconnect a plug of each unit.
2. The stacking plate A and B are contained in accessories bag.
Note: When stacking the unit, 2 stacking plates A and 2 stacking plates B are necessary.
3. Check that the lower unit is level.
4. Remove two caps at 2 locations on the top front of under unit, and apply the protective sticker enclosed
with the unit at each corner on the top of the lower unit to avoid scratches or damage (Fig.A).
5. Fix the stacking plate A at 2 locations on the top front of the lower unit by using 2 screws contained in
accessories bag.
6. Remove the front panel on the upper unit by unscrewing the 4 fixing screws and then disconnect the
wires and gas tube.
7. Stack the unit so that both units can be aligned straight. Also check the upper unit is level. If it is not
level, keep the unit even by adjusting the leveling legs.
8. Secure the upper unit with the stacking plate A and 2 screws contained in accessories bag.
9. Remove 2 screws on the above right and left on the rear side of the lower unit.
10. Remove 1 screw on the bottom right and left on the rear side of the upper unit.
11. Fix the stacking plate B at the right and left on the rear of the lower and upper unit with 3 screws
removed in step 9 and 10.
12. Replace the front panel on the upper unit after connecting the wires and gas tube.
13. Repeat procedures from step 3. when stake more.
14. Fix the stacked unit to the wall with 2 stacking plate B on the rear of the top unit and rope or chain.
Front panel
Stacking plate B
Stacking plate A
Protective sticker
Fig.A View from quarter rear side
54