Lancom OAP-54 Manual page 34

LANCOM OAP-54 Wireless and LANCOM OAP-310agn Wireless
The employment of the AirLancer Extender SA-5L for internal light-

ning protection is essential under all circumstances—the
AirLancer Extender SA-5L is always mounted between the Access
Point and the antenna, preferably as near as possible to the antenna.
Antennas are only to be attached or changed when the device is

switched off. Mounting or demounting antennas while the device
switched on may cause the destruction of the WLAN module!
LAN—The LAN connector is also used to supply power to the LANCOM
OAP Wireless. Plug in the water-proof power cable to the LAN port on the
underside of the device and carefully tighten the threaded connector.
Connect the other end of the power cable to the 'Power Out' connector
on the supplied PoE Injector.
PoE—the 'LAN In' connector of the supplied PoE Injector should be con-
nected via a normal Ethernet cable to an available network connection
socket in your local network (e.g. an available socket on a hub or switch)
and the PoE Injector connected with the electricity supply.
Information about the installation of PoE can be found in the information
box 'Power over Ethernet—elegant power supply over LAN cabling'
above.
Please observe the information in the documentation supplied with the
PoE Injector.
Use the PoE Injector only for the supply of power to PoE-compatible

devices. Pay particular care not to connect the PoE Injector to normal
Ethernet devices!
WAN—if you wish to make use of the integrated DSL router for a direct
WAN connection, plug in the supplied WAN cable to the WAN connector
on the underside of the device
nector. Connect the other end of the WAN cable to an ADSL or cable
modem.
Waterproof WAN cables from LANCOM Systems are available on order

from specialist resellers.
Ready for operation? —the Power LED permanently lights up in green as
soon as the device receives power. After being switched on, the device
Chapter 2: Installation
¸
and carefully tighten the threaded con-
33