Mounting And Connectiong The Lancom Oap-54 Wireless And Lancom Oap-310Agn Wireless - Lancom OAP-54 Manual

LANCOM OAP-54 Wireless and LANCOM OAP-310agn Wireless
Chapter 2: Installation
Reset button functions
The reset button is freely accessible on LANCOM OAP-54 Wireless or LANCOM
OAP-310agn Wireless, hence you cannot reset the device by simply pressing
this button. Detach the LAN cable from the corresponding interface to disable
the power supply via PoE. Keep the reset button pressed when re-attaching
the LAN cable. The message LED will start blinking. After the LEDs has finished
blinking, you can release the button and the device has been reset.


2.5 Mounting and connectiong the LANCOM OAP-54
Wireless and LANCOM OAP-310agn Wireless
Before mounting external antennas, please observe the information on lightning pro-

tection in the LANCOM WLAN Outdoor Manual (available as a download from
www.lancom.eu). Mounting antennas without adequate lightning protection could
lead to serious damage to the access point and the network infrastructure connected
to it.
Wall mounting
30
After resetting, the device starts completely unconfigured and all set-
tings are lost. If possible be sure to backup the current device confi-
guration before resetting.
After resetting, the LANCOM Access Point returns to managed mode,
in which case the configuration cannot be directly accessed via the
WLAN interface!
Your LANCOM OAP Wireless should be mounted with suitable screws
in the required position on the wall. Screws for wall mounting are not sup-
plied with the device.
³