Table of Contents
Advertisement
LANCOM OAP-54 Wireless and LANCOM OAP-310agn Wireless
Chapter 7: Options and accessories
To install an optional AirLancer antenna, switch the device off by unplugging
LANCOM OAP-
310agn Wireless
the power cable. Now carefully unplug the diversity antennas by unscrewing
them. Connect the AirLancer antennas to the antenna connectors marked
'ANT 1' and 'ANT 2' or 'ANT 1' and 'ANT 3'. Each unused antenna connector
is to be deactivated with a terminator (supplied).
LANCOM OAP-54
To install optional AirLancer antennas, switch the device off by unplugging the
Wireless
LAN cable that supplies the power. Carefully unscrew the two diversity anten-
nas from the top of the device (first wireless module). Connect the AirLancer
Extender antenna to the 'Antenna Main' connector.
86
Before mounting external antennas, please observe the information
on lightning protection in the LANCOM Outdoor Wireless Guide (sup-
plied or available as a download from www.lancom.eu). Mounting
antennas without adequate lightning protection could lead to serious
damage to the access point and the network infrastructure connected
to it.
Please note the following when connecting antennas:
Antenna connector 1 must always be used. Depending on the
model, mounting and cabling, the second antenna may be connec-
ted either to connector 2 or connector 3.
The configuration of the device software must agree with the actual
antenna connections.
'Antenna Main' connector
for the first wireless module
WLAN
WLAN
Power LAN
-1
In most cases, the connections between the LANCOM OAP-54
Wireless and the AirLancer Extender antennas require the use of an
adapter cable from "Reverse N" to "N". With this adapter cable it is
'AUX' connector for
the first wireless
module
WAN Message
-2
Advertisement
Table of Contents
