Tcp/Ip Settings - Lancom OAP-54 Manual

Wireless LAN details
Security settings
3.1.1

TCP/IP settings

TCP/IP configuration can be performed in two different ways: Either fully auto-
matically or manually. No user input is required if TCP/IP configuration is per-
formed automatically. All parameters are set by the Setup Wizard on its own.
When manual TCP/IP configuration is performed the wizard prompts for the
usual TCP/IP parameters: IP address, network mask etc. (more on this later)
The fully automatic TCP/IP configuration is only possible in certain network
environments. For this reason the Setup Wwizard analyses the connected LAN
to see whether fully automatic configuration is possible or not.
New LAN – fully automatic configuration possible
The setup wizard offers to configure TCP/IP fully automatically if no network
devices connected have yet been configured. This usually happens in the fol-
lowing situations:
Only a single PC is going to be attached to the LANCOM OAP Wireless
Setting up a new network
Fully automatic TCP/IP configuration will not be offered if you are integrating
the LANCOM OAP Wireless into an existing TCP/IP LAN. In this case please
continue with the section 'Required information for manual TCP/IP configura-
tion'.
The result of fully automatic TCP/IP configuration is as follows: The LANCOM
OAP Wireless is assigned the IP address '172.23.56.254' (network mask
'255.255.255.0'). The integrated DHCP server is also activated so that the
LANCOM OAP Wireless can assign the devices in the LAN IP addresses auto-
matically.
Should you still configure manually?
Fully automatic TCP/IP configuration is optional. Instead of this you can select
manual configuration. Make this selection after considering the following:
Select automatic configuration if you are not familiar with networks and
IP addresses.
Select the manual TCP/IP configuration if you are familiar with networking
and IP addresses, and you would like to specify the IP address for the rou-
ter yourself (from one of the address ranges reserved for private use,
LANCOM OAP-54 Wireless and LANCOM OAP-310agn Wireless
Chapter 3: Basic configuration
37