The Device Connectors - Lancom OAP-54 Manual

Message Gives general information about the device.
Flashing Message-LED but no connection?
There's no need to worry if the Message-LED blinks red and you
con no longer connect to the WAN. This simply indicates that a
preset time or connect-charge limit has been reached.
There are three methods available for unlocking:
Reset connect charge protection.
Increase the limit that has been reached.
Completely deactivate the lock that has been triggered (set
limit to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select Reset Charge and Time Limits in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management Costs (you will only be able to access this configuration if 'Complete con-
figuration display' is selected under View
You will find the connect charge protection reset in WEBconfig and all parameters under:
LCOS Menu Tree Setup
off
red
red
red

2.4

The device connectors

The connections and switches of the LANCOM OAP-54 Wireless and LANCOM
OAP-310agn Wireless are located on the top and bottom side.
On the top are the two antenna connectors. The bottom side accommodates
the LAN and WAN connectors, the reset button and an additional antenna
connector.
LANCOM OAP-54 Wireless and LANCOM OAP-310agn Wireless
Options...).
Charges-module
flashing (slow)
flashing (fast)
flickering
The power LED flashes red when a charge limit is reached.
Device ready for use
Time or connect-charge reached
Device insecure: configuration password not assigned
WLAN module defected
Chapter 2: Installation
Signal for reached time or
charge limit
27