The Connectors - Lancom l-54ag User Manual

LANCOM L- 54ag Wireless – LANCOM L- 54g Wireless – LANCOM IAP- 54 Wireless
Chapter 2: Installation
2.3.2

The connectors

LANCOM L- 54g Wireless, LANCOM L- 54ag Wireless
With the LANCOM L-54g Wireless and LANCOM L-54ag Wireless the connec-
tions and switches of the base station are located on the back panel:
Antenna Aux
16
AC 12 V
Connection for diversity antenna
Connection for the included power adapter
Node/hub switch – the sending and receiving lines of the LAN connector
( ) can be crossed within the device for a direct connection of a PC ('hub'
setting ). For connection to a hub or a switch, the switch should be
turned to 'node' setting
DSLoL, the switch must be turned to 'hub'
DSLmodem.
10/100base-Tx for the connection to the LAN. 10Mbp- or 100Mbp con-
nections are supported. The used transfer speed will automatically be
identified (autosensing).
The LAN connector of the LANCOM 54 Wireless base station supports the
Power-over-Ethernet standard (PoE). You find further information about
operating with PoE in the info box 'Power-over-Ethernet – elegant power
supply through the LAN wiring' →page 17.
By activated DSLoL option, the LAN connector can also be used for con-
necting the LANCOM 54 Wireless base station to a broadband modem.
Connection for the serial configuration cable.
Reset switch – has two different functions depending on the length of
time that it is pressed:
Connector for main antenna (if necessary is here the spot to connect
AirLancer Extender additional antennas)
» ´
¿
Node
Hub LAN 10/100 Mb
(presetting). When using the operating mode
for a directly connected
² ¶
Reset
Antenna Main