Cleaning And Maintenance; General Advice; Enamelled Parts - Elba N96 EX 939 S Instructions For The Use

6

CLEANING AND MAINTENANCE

GENERAL ADVICE

• Before you begin cleaning, you must
ensure that the appliance is switched
off.
• It is advisable to clean when the
appliance is cold and especially when
cleaning the enamelled parts.
• Avoid leaving
substances (lemon juice, vinegar, etc.)
on the surfaces.
• Avoid using cleaning products with a
chlorine or acidic base.
• Do not use a steam cleaner because
the moisture can get into the appliance
thus make it unsafe.
Important:
The use of suitable protective clothing/
gloves is recommended when handling
or cleaning of this appliance.
WARNING
When correctly installed, your product
meets all safety requirements laid
down for this type of product category.
However special care should be taken
around the rear or the underneath of
the appliance as these areas are not
designed or intended to be touched and
may contain sharp or rough edges, that
may cause injury.
VITROCERAMIC COOKING HOB
– See page 14.

ENAMELLED PARTS

All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a microfibre or soft
cloth.
Acidic substances like lemon juice, tomato
sauce, vinegar etc. can damage the enamel
if left too long.
24
alkaline or acidic
STAINLESS STEEL, ALUMINIUM PARTS
AND SILK-SCREEN PRINTED SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be cleaned
very carefully to avoid scratching and
abrasion. You are advised to use a soft
cloth and neutral soap.
CAUTION: Do
substances or non-neutral detergents
as these will irreparably damage the
surface.
INSIDE OF OVEN
• The oven should always be cleaned
after use when it has cooled down.
• Remove and refit the side runner
frames as described on the next
chapter.
• The cavity should be cleaned using
a mild detergent solution and warm
water.
• Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations
and testing a small sample of the oven
cavity.
• Abrasive cleaning agents or scouring
pads/cloths should not be used on the
cavity surface.
• Side runner frames, tray, lower panel
and rack can be removed and washed
in the sink.
NOTE: The manufacturers of this appliance
will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay
special attention no to touch the hot
heating elements inside the oven
cavity.
not use abrasive