Oven Floor - Elba N96 EX 939 S Instructions For The Use

REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the cooker is cool unscrew and
replace the bulb with another one resistant
to high temperatures (300°C), voltage
230V 50 Hz, type E14 and same power
(check watt power as stamped in the bulb
itself) of the replaced bulb.
Note: Oven bulb replacement is not
covered by your guarantee.
ASSEMBLY AND DISMANTLING OF
THE SIDE RUNNER FRAMES
• Fit the side runner frames into the
holes on the side walls inside the oven
(Fig. 6.1).
• Slide the rack into the runners (Fig. 6.2).

The rack must be fitted so that the
safety notch, which stops it sliding out,
faces the inside of the oven; the guard
rail shall be at the back.
• To dismantle, operate in reverse order.
OVEN TRAY
The oven tray must be correctly placed on
the wire shelf (fig. 6.3).

OVEN FLOOR

The oven floor "F" (fig. 6.3) can be easily
removed to facilitate cleaning.
Remember to replace the floor correctly
afterwards.
Be careful not to confuse the tray "L"
with the oven floor "F" (fig. 6.3).
Fig. 6.3
L
F
Guard rail
Fig. 6.2
Fig. 6.1
Stop notch
25