Advertisement
THERMO POT
MODEL: ETP-G5083(CG)
Owner's Manual
Please read this manual carefully before
operating your set.
Retain it for future reference.
Record model number and serial number of
the set.
See the label attached on the set and quote this
information to your dealer when you require
service.
For The Warranty Terms & Conditions, Please Refer To Warranty Certificate.
Advertisement
Table of Contents
Related Manuals for Elba ETP-G5083(CG)
Summary of Contents for Elba ETP-G5083(CG)
- Page 1 THERMO POT MODEL: ETP-G5083(CG) Owner’s Manual Please read this manual carefully before operating your set. Retain it for future reference. Record model number and serial number of the set. See the label attached on the set and quote this information to your dealer when you require service.
-
Page 3: Important Safeguards
IMPORTANT SAFEGUARDS Read this instruction manual carefully before operating the appliance and keep it for future reference. 1. Never immerse the appliance in water or any other liquids, nor rinse it under the tap. 2. Check if the voltage indicated on the appliance corresponded to the local mains voltage before you connect the appliance. -
Page 4: Product Description
PRODUCT DESCRIPTION... - Page 5 OPERATING THE APPLIANCE FOR THE FIRST TIME 1. Wash and rinse water tank with water. 2. Fill water up to full mark. 3. Boil once and discard the water (press the dispense button). REMOVE AND ATTACH THE LID Detach Lid Place the handle towards the rear side of the thermo pot.
-
Page 6: Operating The Appliance
Attach Lid Place the handle towards the rear side of the thermo pot. Press the hinge lock, at the same time insert the shaft of the hinge of the lid into the hinge holder. Ensure that the lid is attached properly and close the lid until it clicks. - Page 7 Keep warm 1. The keep warm function will be activated and the “keep warm” light indicator (in green) will turn on after water boiled. 2. Press the “re-boil” button if cold water had been added or if you wish to re-boil the water again.
-
Page 8: Cleaning And Maintenance
It will take about 3 minutes to re-boil water (with To re-boil water under keep warm mode full water tank) depending on the water 1. Press the “re-boil” button once. “Boil” light temperature. Before re-boiling the water, make sure the indicator (in red) will be on. - Page 9 Red rust-like spots, milky or black Discoloration of the water tank and white floating objects in the water tank. discoloration, and white floating objects are caused by minerals in the water and are not caused by discoloration or deterioration of the water tank itself.
- Page 10 Do not place the thermo pot on or near to hot Do not fill the thermo pot with water above surface. the full mark inside the water tank or lower than the minimum water level to avoid damage to the appliance. Direction to dispose the product This marking indicates that this product should not be disposed with other household wastes...
Need help?
Do you have a question about the ETP-G5083(CG) and is the answer not in the manual?
Questions and answers
What is tbe difference between the model Elba ETP-G5083(Cg) and ELBA ETP- F5018(BR)?