Connect Wired Devices - HomeSecure HS-PRO-01 User Manual

3.2 Connect Wired Devices

If you have any wired devices you wish to connect to the alarm panel, they must be connected to the
green cable joints inside the alarm panel. See below for an overview of the two cable joints.
Input for wired sensors. Connect one wire to Z1/Z2 and the other wire to GND. If the
sensors is connected as NC (normally closed), one of the included 2.2KOhm resistors
must be serially connected. If the sensor is connected as NO (normally open), the resistor
must be connected in parallel.
Output for wired siren. Connect the power wire to Bell and GND. The siren will beep
once when power is connected to the panel. Max. load: 400mA/DC12V.
AUX power output. Supplies power to wired sensors that need it. Max. Load:
100mA/AC10-12V (AC6-8V if the alarm panel is running on backup power).
PGM connection. Controllable output. You can turn it on/off depending on predefined
parameters or by using App/SMS (see morein 14.1 PGM Output Settings). Max. load:
500mA/DC50V.
Land line output. Connect the telephone cable from your telephone to this output.
Land line input. Connect the telephone cable from the wall to this input.
HomeSecure HS-PRO-01 Manual: 22-08-2014
Copyright © 2015 HomeSecure
8